Trendnet TVIP522P User Manual download pdf (Page 12)

TV-IP522P ProView Me

ixel Internet Camera

Connect Ethernet Cable

To connect the camera to your network, connect a Category 5 or better Ethernet cable to

the network cable connector located on the camera’s left side panel, and then attach it to the

network. The Ethernet port will automatically detect and adjust to the speed (10 or 100

Mbps) and polarity (MDI-II or MDI-X) of the connection.

Connect Power using AC Adapter and Power On Camera

To provide power to the camera, connect the AC power adapter to the DC power input connector,

also located on the camera’s rear panel, and then plug it into a suitable power source. As with any

electrical device, make sure the power source and camera are located in an area where it is not

going to get wet or present an electrical hazard.

Note that there is a difference in how the power connection of the infrared lens assembly

connects compared with the 6mm CCTV lens. The infrared lens requires power and therefore it

is equipped with and special adapter to power both the camera and the lens.

CAUTION: The Camera must be used with the power

adapter included with the device.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 76 77

No comments

Trendnet TVIP522P User Manual Page 12