Trendnet TW100 BRF114 User Manual download pdf (Page 39)

Operation and Status

Figure 22: PPPoE Status Screen

Data - PPPoE Screen

Connection

Physical Address

The hardware address of this device, as seen by remote devices

on the Internet. (This is different to the hardware address seen by

devices on the local LAN.)

IP Address

The IP Address of this device, as seen by Internet users. This

address is allocated by your ISP (Internet Service Provider).

Network Mask

The Network Mask associated with the IP Address above.

PPPoE Link Status

This indicates whether or not the connection is currently estab-

lished.

• If the connection does not exist, the "Connect" button can be

used to establish a connection.

• If the connection currently exists, the "Disconnect" button

can be used to break the connection.

Connection Log

• The Connection Log shows status messages relating to the

existing connection.

• The most common messages are listed in the table below.

• The "Clear Log" button will restart the Log, while the Re-

fresh button will update the messages shown on screen.

Buttons

Connect

If not connected, establish a connection to your ISP.

Disconnect

If connected to your ISP, hang up the connection.

Clear Log

Delete all data currently in the Log. This will make it easier to

read new messages.

Refresh

Update the data on screen.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 82 83

No comments

Trendnet TW100 BRF114 User Manual Page 39