Trendnet TW100-BRF114U User Manual download pdf (Page 18)

Broadband Router User Guide

LAN Screen

Use the LAN link on the main menu to reach the LAN screen An example screen is shown

below.

Figure 6: LAN Screen

Data - LAN Screen

TCP/IP

IP Address

IP address for the TW100-BRF114U, as seen from the local LAN. Use

the default value unless the address is already in use or your LAN is

using a different IP address range. In the latter case, enter an unused IP

Address from within the range used by your LAN.

Subnet Mask

The default value 255.255.255.0 is standard for small (class "C")

networks. For other networks, use the Subnet Mask for the LAN

segment to which the TW100-BRF114U is attached (the same value as

the PCs on that LAN segment).

DHCP Server

• If Enabled, the TW100-BRF114U will allocate IP Addresses to

PCs (DHCP clients) on your LAN when they start up. The default

(and recommended) value is Enabled.

• If you are already using a DHCP Server, this setting must be

Disabled, and the existing DHCP server must be re-configured to

treat the TW100-BRF114U as the default Gateway. See the fol-

lowing section for further details.

• The Start IP Address and Finish IP Address fields set the values

used by the DHCP server when allocating IP Addresses to DHCP

clients. This range also determines the number of DHCP clients

supported.

See the following section for further details on using DHCP.

Buttons

Save

Save the data on screen.

Cancel

The "Cancel" button will discard any data you have entered and reload

the file from the Broadband Router.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 98 99

No comments

Trendnet TW100-BRF114U User Manual Page 18